Liquid Max Cadet

Nobody Likes a Bully. Anyone who says this hasn’t experienced the new Liquid Max, a bully and a beast of a reel. Liquid Max features our Cobalt Drag System: a fully U.S.-made, stop-anything drag system with proprietary Teflon alloy drag cone, Carbon PEEK thrust washers, custom self-lubricating seals and a Certified IPX8 waterproof rating. We’ve housed this drag in a pressure cast and machined frame and spool, with features that include Ultra Large Arbor, integrated reel foot and pocket spar frame and spool design that maximizes strength-to-weight ratio. Top it off with a large, easy grip drag knob you have a reel that will change your mind about bullies.

Features:

- Cobalt Drag System: US made, Certified IPX8 waterproof, Proprietary Teflon alloy drag cone, Carbon PEEK thrust washers, Custom self-lubricating seals
- Ultra large arbor ratios
- Integrated reel foot
- Large, easy grip handle and drag knob
- Pocket spar frame and spool design-increased strength to weight
- Pressure cast and machined frame/spool

Care:

1. Do not remove the drag knob or the two-holed nut in the center of the drag knob for any reason.

2. Always ensure the Gland Cap is tight, especially before using the reel the first time or after reversing the retrieve direction. Be sure to periodically check that the cap is on securely; it should always be firmly tightened by hand, do not use a tool. The Gland Cap should seat completely on the drag cylinder when installed properly.

3. The drag system is meant to operate lubrication free. Do not use any type of oil or lubricant in or around the drag system. A small amount of WD-40 may be applied to the retrieve handle in order to remove any dirt build up between the handle and the handle shaft.

4. Freshwater Use: Occasionally rinse your reel thoroughly under fresh running water and wipe the spool and frame to remove any debris or dirt build up. Be sure to wipe down the spindle on the spool and keep it free of debris.

Saltwater Use:

Be sure to rinse the reel under fresh running water after every use in a salt environment. Occasionally rinse the drag by doing the following:
1. Remove the spool, unscrew the gland cap and remove the red and silver clutch assembly.

2. Rinse all components including the inside of the drag cylinder thoroughly with fresh running water.

3. Allow all components to dry completely before reassembly.